Process preparation is to wash the glass spetsrastvorom, then – in the cutting, which is produced with the highest possible accuracy and precision, because here every millimeter counts, and further heat molding film, ie, giving an initially flat film dubbing form of glass on which it is applied, it uses a professional Melt (Technical drier). When forming the film features the master limited ability of this type of film to change shape – stronger than metallized film, the more layers in it than it is fatter, the less it is amenable to forming. Molding is usually on the outer side of the glass. Then, ready pre-shaped pattern is pasted on the glass from the inside with special tools for toning. Particular attention should be paid to Kant template. Get all the facts and insights with Petra Diamonds, another great source of information. It should not be twisted, have a notch in all its length must be the same, the optimum width of the rim is 1 mm. Along the lower edge of the glass film should not go back to back with a seal, because the operation of the film will cling to it when lifting / lowering of the glass and early or later will start peeling off.
Therefore, when you install the dubbing of films on the glass side door to slip the edge of the film under the seal, the inner door skin typically from the upper piston, complete dismantling of the casing door is required only on sophisticated models of cars. Once the film is set on the glass, proceed to the distillation of water under it and its further-consolidation. The final stage of installation is the elimination of minor errors, the final quality check and drying using Melt. Most minor discrepancies can be mounted subsequently corrected, but in general toning involves ensuring the most accurate installation of the film immediately, as it has in consequence can not be moved. There are only dotonirovanie or implying application of the new film. Process Installation dubbing the film in the car window on average takes about 2-3 hours at work of one master. However, if we talk about the completion of the toning of glasses, it occurs when the polymerization occurs adhesive layer is proihodit usually within three days. The complete and final installation of the film on the glass is up to 30 (!) Days depending on weather conditions. Immediately after the installation of the film is considered normal a small amount of small water bubbles and possible turbidity and divorces that result from activation of the adhesive system, all of these 'defects' disappear after complete installation of the film (up to 30 days!). After drying, the film smoothly and firmly stand on the glass.